Please wait while the page loads...

Is it safe to drive your 2016 Ram 3500 with the check engine light on?

This question is not very prevalent because it all depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be secure to commute. This is regularly indicated by a steady glow of the check engine light. If you notice a variety in the performance of the car, it could be an indication of a more serious problem. If the check engine light is blinking, this means that there is a serious issue and it is recommended to service your Ram 3500 instantly. Call the experts at Mike Shaw Chrysler Dodge Jeep Ram by dialing 9702364701 so you can describe the issues. Or lower your speed and bring your 2016 Ram to our certified mechanics as soon as likely.

What could cause the check engine light to come on in a 2016 Ram 3500?

When your check engine light comes on, this could be as simple as tightening or replacing your gas cap. Likewise, the check engine light could also be a warning of a serious problem that could cause serious damage to your engine and come with a hefty repair bill. Depending on your make and model, the check engine light will illuminate or blink. A steady glow typically means something less serious but a flashing check engine light indicates that your vehicle’s engine is in serious trouble and service is needed immediately. If your check engine light is flashing in your 2016 Ram 3500, we highly recommend not to drive the vehicle and schedule Ram service today. Below is a list of the most common reasons your check engine light can come on:

  • Issues with any aftermarket items. An aftermarket alarm, exhaust or other item can wreak havoc on your 2016 Ram 3500 if it’s not installed correctly. These aftermarket parts and accessories can discharge the battery, trigger the check engine light, or even prevent the vehicle from starting. If these issues sound appreciative, bring your 3500 to Ram and keep our company of certified mechanics ensure that your aftermarket items were installed correctly and aren't causing any issue. Getting accessories, chiefly aftermarket parts and accessories, or using OEM parts first place might cost a little bit more but could save you money from having to get small function and damage caused by small installation function corrected.
  • Your mass airflow sensor (known as MAF) needs to be replaced. The mass airflow sensor in your Ram 3500 is what determines how much fuel is fundamental to run your engine efficiently by measuring the payment of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to positive changes, like altitude. If your Ram 3500 is having trouble starting, idling rough or has a brisk change in the position of the throttle pedal, this could be a sign of a bad mass airflow sensor.
  • Your catalytic converter is bad or going bad. The catalytic converter is a part of your 2016 Ram 3500’s exhaust system. The catalytic converter's function is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is usually caused by neglected maintenance, which is why Mike Shaw Chrysler Dodge Jeep Ram offers a complimentary multi-point inspection with every Ram service. If you keep an issue with your catalytic converter and don't get it repaired, your 2016 Ram 3500 will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your car may run at a higher temperature, too, which can cause other problems from overheating.
  • One of the most usual and bountiful cause is that your 2016 Ram 3500 gas cap is loose, damaged or missing. The gas cap for your 2016 Ram 3500 serves multiple purposes. It prevents gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you keep a bad fuel cap? If your gas cap is erstwhile or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump. Luckily, to replace a gas cap isn't lavish. If your check engine light turns on urgently after you put gas in your 2016 Ram 3500, first thing you should check is to make positive the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.
  • The battery is low or dead. The battery in your 2016 Ram 3500 is every certain. Without a car battery, your car won’t start, light up the road ahead, play the radio or charge your phone. Today’s car batteries last much longer than they did a few decades ago, and they don't actually require maintenance. The price of a new one depends on the type of Ram you drive, but check our present service coupons and specials.
  • So what happens if I don’t replace your O2 sensor? A faulty sensor can not only affect your miles per gallon, but it can cause damage to your catalytic converter and your 2016 Ram 3500's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to mean the noble mixture of air and fuel that enters the cylinders in your engine. A bad O2 sensor can also cause a car to fail an emissions test.
  • Your O2 Sensor (Oxygen Sensor) needs to be replaced. The Oxygen sensor, established as the O2 sensor, measures the payment of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns faster and your vehicle will be less efficient when it comes to fuel economy.
  • New Spark Plugs or Plug Wires are fundamental for your 2016 Ram 3500. The spark plugs are the part of your engine that ignites the air/fuel mixture in the combustion chamber of your vehicle. This explosion is what moves the pistons and makes the engine run. The spark plug wires deliver the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are bad or erstwhile, you will experience small performance and reduced power. In some extreme cases, your engine will keep trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or damage to ignition coils and O2 sensors, big to more lavish repairs.
  • Your 2016 Ram 3500 has a vacuum leak. Every Ram 3500 has a vacuum system that performs a expanded variety of functions. The vacuum system also helps rebate harmful emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can dry out and crack, chiefly if they’re exposed to profound heat or extreme cold.

Check Engine Light Service 2016 Ram 3500

What do you do when you’re driving along in your Ram 3500 and suddenly, a yellow light illuminates on your dash and says "Check Engine". If you’re like most Ram owners, your heart sinks a little because you have little idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the cost of the unknown) can be just as stressful. But take a deep breath and realize the light coming on doesn’t mean you have to pull the car over to the side of the road and call a tow truck, but it is recommended that you get your 2016 Ram 3500 checked as soon as possible. Ignoring that warning could end up causing major damage to expensive engine components.

When your 2016 Ram 3500's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the electronic control system that it can’t correct, a computer turns on your check engine light. This amber or yellow light is typically labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that identifies as the issue, whether it's a sensor or a failing engine part. This code is read with an electronic scan tool that is used by our Ram auto repair mechanics at Mike Shaw Chrysler Dodge Jeep Ram. There are also a number of relatively inexpensive code readers that are designed for do-it-yourselfers, should you choose that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an experienced professional to determine the issue and repair it.

How many miles can you drive with the check engine light?

If you check engine light is flashing, we advise that you pull over and contact Mike Shaw Chrysler Dodge Jeep Ram to help select if your vehicle is safe to travel to work in or if we advise a tow truck. Since any check engine code has its own level of severity, it is complicated to predict how frequent miles you can travel to work with the warning light on. The safest bet is to decipher the code and then plan your strategy accordingly. It could be anything from a bad sensor to plug wires needing to be replaced.

2016 Ram 3500 Check Engine Light

A twinkling light indicates that the problem is sincere and if not taken care of shortly may result in adequate damage to the vehicle. If the check engine light in your 2016 Ram 3500 starts twinkling, that means that the problem needs immediate attention and your Ram should be brought in shortly. This blinking light usually indicates a severe engine misfire allowing unburned fuel to be dumped into the exhaust system. There it can quickly raise the temperature of the catalytic converter to a point where damage is likely, requiring an expensive repair. Some owners ask if spark plugs cause the check engine light to flash? This can absolutely be the cause. A bad, old or dirty spark plug can cause the engine to misfire. If your check engine light is twinkling, please contact our team of automotive consultants at Mike Shaw Chrysler Dodge Jeep Ram suddenly by calling 9702364701. If the problem is ignored or you continue to drive, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a highly expensive repair.

2016 Ram 3500 Check Engine Light Flashing

Although there are countless potential causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are several common causes including something as simple as a loose gas cap. Other common reasons for a Check Engine Light are faulty emissions control part, damaged oxygen sensor, faulty head gasket, dirty mass airflow sensor, a malfunction with the fuel injection system, or defective spark plugs to name a few. No matter what is the root cause of the Check Engine Light, we have the Ram Certified Technicians and the certified service protocol to isolate the root problem and repair it as needed to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Ram issue was fixed.

Every 2016 Ram 3500 was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the vehicle on its crucial systems. The sensors are continually detecting conditions while sending data to the electronic control unit. If the electronic control unit detects that the data is out of factory specifications, the Check Engine Light illuminates telling you that there is a problem. However, that is the limitation of the Check Engine Light – it won’t tell you what exactly is wrong nor what to do about it. That’s where we come in; Mike Shaw Chrysler Dodge Jeep Ram provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Highly Qualified Service professional.

What Does the Check Engine Light Mean?

One of the most commonly misunderstood lights or indicators in your 2016 Ram 3500 is the check engine light. The check engine light is part of the onboard diagnostics system, and displays in a few different ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light illuminates in either an amber or red color and is part of the diagnostics system found on your vehicle. Onboard computers increasingly have controlled and monitored vehicle performance since the 80s and do a variety of things for your 2016 Ram 3500. Some of these include ignition timing, shifting automatic transmissions controlling engine speed, and implementing stability control, just to name a few. With that being said, the check engine light can mean a variety of different things. It can be as simple as your gas cap being loose or as serious as engine knocking. If your check engine light is on in your 2016 Ram 3500, contact Mike Shaw Chrysler Dodge Jeep Ram. Contact Mike Shaw Chrysler Dodge Jeep Ram today! Our Ram service department can help you read what code is turning your check engine light on or diagnose why your check engine light is flashing.

How much does it cost to get the engine light checked?

The check engine light warns of issues ranging from a gas cap that's not subsequently tightened to a more dangerous failure like a bad catalytic converter or a problem with one of the car's oxygen sensors, so it adept to get the suitable code reading and diagnosis. The intermediate price for a check engine light diagnosis & testing is customarily between $88 and $111. The adept news, Mike Shaw Chrysler Dodge Jeep Ram offers complimentary multi-point inspections and free diagnostics, in most cases, to aid represent the cause of your check engine light.

2016 Ram 3500 Check Engine Light Codes

The check engine light turning on can be quite intimidating to see that little light on your vehicle’s dashboard suddenly illuminates, but in reality, it is not something that should cause you to shut down in fear right away. If you hear the term, diagnostic trouble codes (DTC), these are just another name for check engine light codes. These are automotive computer codes stored by the ECM, also known as the OBD (on-board computer diagnostic system) in your 3500. There are hundreds of different codes that your check engine light can represent. While that sounds daunting, with a little patience, tackling basic diagnostics will give you useful knowledge about your vehicle and will also allow that Check Engine Light to do what it is really supposed to do: be your guide. Unfortunately, obvious and helpful vehicle symptoms do not always accompany an illuminated Check Engine Light. Since there are hundreds of possible OBD codes, there are also hundreds of possible reasons for the light, including:

  • Old Battery
  • Loose Gas Cap or Missing Gas Cap
  • Ignition system faults
  • O2 Sensor
  • Computer output circuit issues
  • Bad Spark Plugs
  • Emissions controls issues
  • Transmission issues
  • Fuel and air metering systems problems
This is why it is important for someone who does not have a lot of automotive knowledge to not assume what a code means. Call Mike Shaw Chrysler Dodge Jeep Ram at 9702364701 quickly or schedule your check engine light service online today! When your check engine light comes on, you should get it checked out promptly by a certified Ram mechanic. If the engine light comes on due to a thoughtful concern, you risk damaging your car added by not repairing the issue honorable away.

Will the check engine light reset itself?

The check engine light on your 2016 Ram 3500 will usually shut itself off if the issue or code that caused it to turn on is fixed. For example, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will turn itself off. Likewise, if your catalytic converter is going functional, and you did a lot of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your 2016 Ram 3500 light will go off after about 20-40 miles. If you drive over that amount and the light is still on, you will need to bring it in to Mike Shaw Chrysler Dodge Jeep Ram so the light and code can be double-checked and reset.