Please wait while the page loads...

How much does it cost to get the engine light checked?

The check engine light warns of issues ranging from a gas cap that's not properly tightened to a more efficient failure like a bad catalytic converter or a problem with one of the car's oxygen sensors, so it gargantuan to get the apt code reading and diagnosis. The intermediate price for a check engine light diagnosis & testing is typically between $88 and $111. The gargantuan news, Mike Shaw Chrysler Dodge Jeep Ram offers complimentary multi-point inspections and free diagnostics, in most cases, to help learn the cause of your check engine light.

Will the check engine light reset itself?

The check engine light on your 2013 Ram 5500 will frequently shut itself off if the issue or code that caused it to turn on is serviced. For example, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will turn itself off. Likewise, if your catalytic converter is going active, and you did assorted of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your 2013 Ram 5500 light will go off after about 20-40 miles. If you drive over that fee and the light is still on, you will need to bring it in to Mike Shaw Chrysler Dodge Jeep Ram so the light and code can be double-checked and reset.

2013 Ram 5500 Check Engine Light

If the check engine light in your 2013 Ram 5500 starts blinking, that means that the problem needs hasty attention and your Ram should be brought in quickly. A blinking light indicates that the problem is important and if not taken care of quickly may result in major damage to the car. This blinking light usually indicates a exacting engine misfire allowing unburned fuel to be dumped into the exhaust system. There it can rapidly boost the temperature of the catalytic converter to a point where damage is conceivable, requiring an lavish repair. Some owners ask if spark plugs cause the check engine light to flash? This can certainly be the cause. A bad, traditional or dirty spark plug can cause the engine to misfire. If the problem is ignored or you continue to drive, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a excessively expensive repair. If your check engine light is glaring, please contact our company of automotive experts at Mike Shaw Chrysler Dodge Jeep Ram instantly by calling 9702364701.

What Does the Check Engine Light Mean?

One of the most constantly misunderstood lights or indicators in your 2013 Ram 5500 is the check engine light. The check engine light is part of the onboard diagnostics system, and displays in some disparate ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light lights up in either an amber or red color and is part of the diagnostics system found on your vehicle. Onboard computers increasingly have controlled and monitored vehicle performance since the 80s and do a collection of things for your 2013 Ram 5500. Some of these include ignition timing, controlling engine speed, shifting automatic transmissions and implementing stability control, just to name some. With that being said, the check engine light can mean a variety of different things. It can be as uncomplicated as your gas cap being loose or as threatening as engine knocking. If your check engine light is on in your 2013 Ram 5500, contact Mike Shaw Chrysler Dodge Jeep Ram. Contact Mike Shaw Chrysler Dodge Jeep Ram today! Our Ram service department can help you find out what code is turning your check engine light on or diagnose why your check engine light is flashing.

How many miles can you drive with the check engine light?

It could be anything from a damaging sensor to plug wires needing to be interchanged. Since each check engine code has its own level of severity, it is difficult to predict how bountiful miles you can drive with the warning light on. The safest bet is to decipher the code and then plan your strategy accordingly. If you check engine light is shining, we recommend that you pull over and contact Mike Shaw Chrysler Dodge Jeep Ram to help designate if your vehicle is safe to drive in or if we recommend a tow truck.

What could cause the check engine light to come on in a 2013 Ram 5500?

When your check engine light comes on, this could be as nice as tightening or replacing your gas cap. Likewise, the check engine light could also be a warning of a hazardous problem that could cause hazardous damage to your engine and come with a big repair bill. Depending on your make and model, the check engine light will illuminate or blink. A steady glow mostly means something less hazardous but a flashing check engine light indicates that your vehicle’s engine is in hazardous trouble and service is needed immediately. If your check engine light is flashing in your 2013 Ram 5500, we extremely advise not to travel to work the vehicle and schedule Ram service straightaway. Below is a list of the most commonplace reasons your check engine light can come on:

  • Issues with any aftermarket items. An aftermarket alarm, exhaust or distinctive item can wreak havoc on your 2013 Ram 5500 if it’s not installed properly. These aftermarket parts and accessories can drain the battery, trigger the check engine light, or even prevent the car from starting. If these issues sound admitted, bring your 5500 to Ram and have our team of certified mechanics ensure that your aftermarket items were installed properly and aren't causing any issue. Getting accessories, especially aftermarket parts and accessories, or using OEM parts first place might cost a few bit more but could save you money from having to get low function and damage caused by low installation function corrected.
  • One of the most known and many cause is that your 2013 Ram 5500 gas cap is loose, damaged or missing. The gas cap for your 2013 Ram 5500 serves multiple purposes. It prevents gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a bad fuel cap? If your gas cap is old or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump. Luckily, to replace a gas cap isn't expensive. If your check engine light turns on urgently after you put gas in your 2013 Ram 5500, first thing you should check is to make convinced the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.
  • Your O2 Sensor (Oxygen Sensor) needs to be changed. The Oxygen sensor, known as the O2 sensor, measures the amount of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns faster and your car will be fewer efficient when it comes to fuel economy. So what happens if I don’t replace your O2 sensor? A faulty sensor can not only affect your miles per gallon, but it can cause damage to your catalytic converter and your 2013 Ram 5500's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to indicate the proper range of air and fuel that enters the cylinders in your engine. A bad O2 sensor can also cause a car to fail an emissions test.
  • The battery is low or dead. The battery in your 2013 Ram 5500 is every exceptional. Without a car battery, your car won’t start, light up the road ahead, play the radio or charge your phone. Today’s car batteries last much longer than they did a few decades ago, and they don't really require maintenance. The price of a new one depends on the type of Ram you drive, but check our modern service coupons and specials.
  • Your catalytic converter is bad or going bad. The catalytic converter is a part of your 2013 Ram 5500’s exhaust system. The catalytic converter's function is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is usually caused by neglected maintenance, which is why Mike Shaw Chrysler Dodge Jeep Ram offers a complimentary multi-point inspection with every Ram service. If you have an issue with your catalytic converter and don't get it repaired, your 2013 Ram 5500 will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your car may run at a higher temperature, too, which can cause distinctive problems from overheating.
  • Your 2013 Ram 5500 has a vacuum leak. Every Ram 5500 has a vacuum system that performs a roomy variety of functions. The vacuum system also helps lower harmful emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can dry out and crack, especially if they’re exposed to colossal heat or extreme cool.
  • New Spark Plugs or Plug Wires are imperative for your 2013 Ram 5500. The spark plugs are the part of your engine that ignites the air/fuel range in the combustion chamber of your car. This explosion is what moves the pistons and makes the engine run. The spark plug wires deliver the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are bad or old, you will experience low performance and reduced power. In some extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or damage to ignition coils and O2 sensors, leading to more expensive repairs.
  • Your mass airflow sensor (known as MAF) needs to be changed. The mass airflow sensor in your Ram 5500 is what determines how much fuel is imperative to run your engine efficiently by measuring the amount of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to conscious changes, like altitude. If your Ram 5500 is having trouble starting, idling rough or has a abrupt change in the position of the throttle pedal, this could be a sign of a bad mass airflow sensor.

2013 Ram 5500 Check Engine Light Flashing

Although there are countless potential causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are several commonplace causes including something as easy as a loose gas cap. Explicit commonplace reasons for a Check Engine Light are faulty head gasket, faulty emissions control part, damaged oxygen sensor, dirty mass airflow sensor, a malfunction with the fuel injection system, or defective spark plugs to name a few. No matter what is the root cause of the Check Engine Light, we have the Ram Certified Mechanics and the certified service protocol to isolate the root problem and repair it as decisive to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Ram issue was fixed.

Every 2013 Ram 5500 was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the vehicle on its normal systems. The sensors are continually detecting conditions while sending data to the electronic control department. If the electronic control department detects that the data is out of factory specifications, the Check Engine Light illuminates telling you that there is a problem. However, that is the limitation of the Check Engine Light – it won’t tell you what exactly is awry nor what to do about it. That’s where we come in; Mike Shaw Chrysler Dodge Jeep Ram provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Highly Qualified Service professional.

2013 Ram 5500 Check Engine Light Codes

The check engine light turning on can be quite intimidating to see that tiny light on your vehicle’s dashboard suddenly illuminates, but in reality, it is not something that should cause you to shut down in fear good away. If you hear the term, diagnostic trouble codes (DTC), these are just another name for check engine light codes. These are automotive computer codes stored by the ECM, also known as the OBD (on-board computer diagnostic system) in your 5500. There are hundreds of different codes that your check engine light can represent. While that sounds daunting, with a tiny patience, tackling natural diagnostics will give you enthusiastic knowledge about your vehicle and will also allow that Check Engine Light to do what it is really supposed to do: be your guide. Unfortunately, discernable and helpful vehicle symptoms do not always accompany an illuminated Check Engine Light. Since there are hundreds of enthusiastic OBD codes, there are also hundreds of enthusiastic reasons for the light, including:

  • Loose Gas Cap or Missing Gas Cap
  • Computer output circuit issues
  • Fuel and air metering systems problems
  • Emissions controls issues
  • Bad Spark Plugs
  • Transmission issues
  • Old Battery
  • O2 Sensor
  • Ignition system faults

This is why it is persuasive for someone who does not have a lot of automotive knowledge to not assume what a code means. When your check engine light comes on, you should get it checked out hastily by a certified Ram mechanic. Call Mike Shaw Chrysler Dodge Jeep Ram at 9702364701 today or schedule your check engine light service online today! If the engine light comes on due to a rigid concern, you risk damaging your vehicle supplemental by not repairing the issue proper away.

Check Engine Light Service 2013 Ram 5500

What do you do when you’re driving along in your Ram 5500 and quickly, a yellow light illuminates on your dash and says "Check Engine". If you’re like most Ram owners, your heart sinks a little because you have little idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the cost of the unknown) can be just as stressful. But take a deep breath and realize the light coming on doesn’t represent you have to pull the automobile over to the side of the road and call a tow truck, but it is recommended that you get your 2013 Ram 5500 checked as soon as conceivable. Ignoring that warning could end up causing extensive damage to fancy engine components.

When your 2013 Ram 5500's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the electronic control system that it can’t decent, a computer turns on your check engine light. This amber or yellow light is usually labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that identifies as the issue, whether it's a sensor or a failing engine part. This code is read with an mechanical investigate tool that is used by our Ram auto repair mechanics at Mike Shaw Chrysler Dodge Jeep Ram. There are also a number of rather inexpensive code readers that are designed for do-it-yourselfers, should you choose that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an experienced experienced to mean the issue and repair it.

Is it safe to drive your 2013 Ram 5500 with the check engine light on?

This question is not very clear because it all depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be secure to travel to work. This is generally indicated by a steady glow of the check engine light. If you notice a difference in the performance of the vehicle, it could be an indication of a more alarming problem. If the check engine light is twinkling, this means that there is a alarming issue and it is recommended to service your Ram 5500 swiftly. Call the experts at Mike Shaw Chrysler Dodge Jeep Ram by dialing 9702364701 so you can describe the issues. Or cut down your speed and bring your 2013 Ram to our certified technicians as soon as reasonable.