Please wait while the page loads...

What could cause the check engine light to come on in a 2013 Ram 4500?

When your check engine light comes on, this could be as uncomplicated as tightening or replacing your gas cap. Likewise, the check engine light could also be a warning of a remarkable problem that could cause remarkable damage to your engine and come with a intense repair bill. Depending on your make and model, the check engine light will illuminate or blink. A logical glow normally means something less remarkable but a flashing check engine light indicates that your vehicle’s engine is in remarkable trouble and service is imperative suddenly. If your check engine light is flashing in your 2013 Ram 4500, we tremendously suggest not to drive the vehicle and schedule Ram service today. Below is a list of the most uncomplicated reasons your check engine light can come on:

  • Your O2 Sensor (Oxygen Sensor) needs to be replaced. The Oxygen sensor, natural as the O2 sensor, measures the amount of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns faster and your vehicle will be less accessible when it comes to fuel economy. So what happens if I don’t replace your O2 sensor? A faulty sensor can not only affect your miles per gallon, but it can cause damage to your catalytic converter and your 2013 Ram 4500's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to imply the proper mixture of air and fuel that enters the cylinders in your engine. A bad O2 sensor can also cause a car to fail an emissions test.
  • One of the most accessible and frequent cause is that your 2013 Ram 4500 gas cap is loose, damaged or missing. The gas cap for your 2013 Ram 4500 serves multiple purposes. It prevents gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a bad fuel cap? If your gas cap is erstwhile or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump. Luckily, to replace a gas cap isn't expensive. If your check engine light turns on immediately after you put gas in your 2013 Ram 4500, original thing you should check is to make confident the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.
  • Issues with any aftermarket items. An aftermarket alarm, exhaust or alternative item can wreak havoc on your 2013 Ram 4500 if it’s not installed properly. These aftermarket parts and accessories can eject the battery, trigger the check engine light, or even avoid the vehicle from starting. If these issues sound natural, bring your 4500 to Ram and have our department of certified mechanics ensure that your aftermarket items were installed correctly and aren't causing any issue. Getting accessories, especially aftermarket parts and accessories, or using OEM parts original place might cost a little bit more but could save you money from having to get poor work and damage caused by poor installation work corrected.
  • Your 2013 Ram 4500 has a vacuum leak. Every Ram 4500 has a vacuum system that performs a wide variety of functions. The vacuum system also helps lower harmful emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can dry out and crack, especially if they’re exposed to notable heat or extreme cold.
  • Your mass airflow sensor (known as MAF) needs to be replaced. The mass airflow sensor in your Ram 4500 is what determines how much fuel is necessary to run your engine efficiently by measuring the amount of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to solid changes, like altitude. If your Ram 4500 is having trouble starting, idling rough or has a fast change in the position of the throttle pedal, this could be a sign of a bad mass airflow sensor.
  • New Spark Plugs or Plug Wires are necessary for your 2013 Ram 4500. The spark plugs are the part of your engine that ignites the air/fuel mixture in the combustion chamber of your vehicle. This explosion is what moves the pistons and makes the engine run. The spark plug wires bring the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are bad or erstwhile, you will experience poor performance and reduced power. In some extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or damage to ignition coils and O2 sensors, extensive to more expensive repairs.
  • The battery is low or dead. The battery in your 2013 Ram 4500 is every big. Without a car battery, your car won’t start, light up the road ahead, play the radio or charge your phone. Today’s car batteries last much longer than they did assorted decades ago, and they don't really require maintenance. The rate of a new one depends on the type of Ram you drive, but check our accessible service coupons and specials.
  • Your catalytic converter is bad or going bad. The catalytic converter is a part of your 2013 Ram 4500’s exhaust system. The catalytic converter's function is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is ordinarily caused by neglected maintenance, which is why Mike Shaw Chrysler Dodge Jeep Ram offers a complimentary multi-point inspection with every Ram service. If you have an issue with your catalytic converter and don't get it revamped, your 2013 Ram 4500 will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your car may run at a higher temperature, too, which can cause alternative problems from overheating.

Is it safe to drive your 2013 Ram 4500 with the check engine light on?

This question is not particularly commonplace because it all depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be safe to drive. This is commonly indicated by a dependable glow of the check engine light. If you notice a difference in the performance of the vehicle, it could be an indication of a more precarious problem. If the check engine light is flashing, this means that there is a precarious issue and it is recommended to service your Ram 4500 abruptly. Call the specialists at Mike Shaw Chrysler Dodge Jeep Ram by dialing 9702364701 so you can describe the issues. Or lower your speed and transport your 2013 Ram to our certified mechanics as soon as ability.

Will the check engine light reset itself?

The check engine light on your 2013 Ram 4500 will usually shut itself off if the issue or code that caused it to turn on is fixed. For example, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will turn itself off. Likewise, if your catalytic converter is going essential, and you did a lot of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your 2013 Ram 4500 light will go off after about 20-40 miles. If you drive over that deposit and the light is still on, you will need to bring it in to Mike Shaw Chrysler Dodge Jeep Ram so the light and code can be double-checked and reset.

What Does the Check Engine Light Mean?

One of the most commonly misunderstood lights or indicators in your 2013 Ram 4500 is the check engine light. The check engine light is part of the onboard diagnostics system, and displays in a lot different ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light illuminates in either an amber or red color and is part of the diagnostics system found on your automobile. Onboard computers increasingly have controlled and monitored automobile performance since the 80s and do a variety of things for your 2013 Ram 4500. Some of these include controlling engine speed, ignition timing, shifting automatic transmissions and implementing stability control, just to name a few. With that being said, the check engine light can mean a variety of clear things. It can be as effortless as your gas cap being loose or as dangerous as engine knocking. If your check engine light is on in your 2013 Ram 4500, contact Mike Shaw Chrysler Dodge Jeep Ram. Contact Mike Shaw Chrysler Dodge Jeep Ram today! Our Ram service department can help you find out what code is turning your check engine light on or observe why your check engine light is flashing.

2013 Ram 4500 Check Engine Light Flashing

Although there are plentiful capability causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are assorted natural causes encompassing something as effortless as a loose gas cap. Extra natural reasons for a Check Engine Light are faulty head gasket, faulty emissions control part, a malfunction with the fuel injection system, dirty mass airflow sensor, damaged oxygen sensor, or defective spark plugs to name a little. No matter what is the root cause of the Check Engine Light, we have the Ram Certified Technicians and the certified service protocol to isolate the root problem and repair it as necessary to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Ram issue was fixed.

Every 2013 Ram 4500 was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the vehicle on its massive systems. The sensors are continually detecting conditions while sending data to the electrical control unit. If the electrical control unit detects that the data is out of factory specifications, the Check Engine Light illuminates telling you that there is a problem. However, that is the limitation of the Check Engine Light – it won’t tell you what strictly is wrong nor what to do about it. That’s where we come in; Mike Shaw Chrysler Dodge Jeep Ram provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Extremely Qualified Service experienced.

How many miles can you drive with the check engine light?

Since all check engine code has its own level of severity, it is not comfortable to predict how countless miles you can drive with the warning light on. If you check engine light is flashing, we recommend that you pull over and contact Mike Shaw Chrysler Dodge Jeep Ram to help choose if your vehicle is compelling to drive in or if we recommend a tow truck. The safest bet is to decipher the code and then plan your strategy appropriately. It could be anything from a bad sensor to plug wires needing to be replaced.

How much does it cost to get the engine light checked?

The check engine light warns of issues ranging from a gas cap that's not properly tightened to a more hazardous failure like a bad catalytic converter or a problem with one of the car's oxygen sensors, so it admirable to get the detectable code reading and diagnosis. The average price for a check engine light diagnosis & testing is generally between $88 and $111. The admirable news, Mike Shaw Chrysler Dodge Jeep Ram offers complimentary multi-point inspections and free diagnostics, in most cases, to help represent the cause of your check engine light.

Check Engine Light Service 2013 Ram 4500

What do you do when you’re driving along in your Ram 4500 and hastily, a yellow light illuminates on your dash and says "Check Engine". If you’re like most Ram owners, your heart sinks some because you have little idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the cost of the unknown) can be just as stressful. But take a deep breath and realize the light coming on doesn’t mean you have to pull the car over to the side of the road and call a tow truck, but it is recommended that you get your 2013 Ram 4500 checked as soon as conceivable. Ignoring that warning could end up causing central wear and tear to expensive engine components.

When your 2013 Ram 4500's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the electronic control system that it can’t appropriate, a computer turns on your check engine light. This amber or yellow light is customarily labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that identifies as the issue, whether it's a sensor or a failing engine part. This code is learn with an electrical investigate tool that is used by our Ram auto repair mechanics at Mike Shaw Chrysler Dodge Jeep Ram. There are also a number of relatively inexpensive code readers that are designed for do-it-yourselfers, should you choose that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an productive experienced to represent the issue and repair it.

2013 Ram 4500 Check Engine Light Codes

The check engine light turning on can be quite intimidating to see that little light on your vehicle’s dashboard rapidly illuminates, but in reality, it is not something that should cause you to shut down in fear decent away. If you hear the term, diagnostic trouble codes (DTC), these are just additional name for check engine light codes. These are automotive computer codes stored by the ECM, also current as the OBD (on-board computer diagnostic system) in your 4500. There are hundreds of substitute codes that your check engine light can choose. While that sounds daunting, with a little patience, tackling basic diagnostics will give you relevant knowledge about your vehicle and will also allow that Check Engine Light to do what it is truly supposed to do: be your guide. Unfortunately, definite and constitutional vehicle symptoms do not always accompany an illuminated Check Engine Light. Since there are hundreds of conceivable OBD codes, there are also hundreds of conceivable reasons for the light, including:

  • Computer output circuit issues
  • Old Battery
  • Ignition system faults
  • Bad Spark Plugs
  • Loose Gas Cap or Missing Gas Cap
  • Emissions controls issues
  • O2 Sensor
  • Fuel and air metering systems problems
  • Transmission issues

This is why it is momentous for someone who does not have a lot of automotive knowledge to not assume what a code means. If the engine light comes on due to a perilous concern, you risk harmful your car further by not repairing the issue honest away. Call Mike Shaw Chrysler Dodge Jeep Ram at 9702364701 at this moment or schedule your check engine light service online today! When your check engine light comes on, you should get it checked out instantly by a certified Ram mechanic.

2013 Ram 4500 Check Engine Light

A twinkling light indicates that the problem is important and if not taken care of hastily may result in gigantic damage to the vehicle. If the check engine light in your 2013 Ram 4500 starts twinkling, that means that the problem needs hasty attention and your Ram should be brought in hastily. This blinking light usually indicates a rigorous engine misfire allowing unburned fuel to be ejected into the exhaust system. There it can rapidly hike the temperature of the catalytic converter to a point where damage is achievable, requiring an expensive repair. Assorted owners ask if spark plugs cause the check engine light to flash? This can precisely be the cause. A damaging, erstwhile or dirty spark plug can cause the engine to misfire. If the problem is ignored or you continue to drive, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a very expensive repair. If your check engine light is blinking, please contact our team of automotive experts at Mike Shaw Chrysler Dodge Jeep Ram swiftly by calling 9702364701.