Please wait while the page loads...

How many miles can you drive with the check engine light?

Since any check engine code has its own level of severity, it is difficult to predict how copious miles you can drive with the warning light on. The safest bet is to decipher the code and then plan your strategy accordingly. It could be anything from a aggressive sensor to plug wires needing to be replaced. If you check engine light is glaring, we recommend that you pull over and contact Mike Shaw Chrysler Dodge Jeep Ram to help pick if your vehicle is safe to drive in or if we recommend a tow truck.

2012 Ram 5500 Check Engine Light Flashing

Although there are countless feasible causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are innumerable contemporary causes including something as conspicuous as a loose gas cap. Diversified contemporary reasons for a Check Engine Light are damaged oxygen sensor, faulty emissions control part, dirty mass airflow sensor, faulty head gasket, a malfunction with the fuel injection system, or defective spark plugs to name a few. No matter what is the root cause of the Check Engine Light, we have the Ram Certified Technicians and the certified service protocol to isolate the root problem and repair it as basic to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Ram issue was fixed.

Every 2012 Ram 5500 was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the vehicle on its severe systems. The sensors are continually detecting conditions while sending data to the electronic control unit. If the electronic control unit detects that the data is out of factory specifications, the Check Engine Light illuminates telling you that there is a problem. However, that is the limitation of the Check Engine Light – it won’t tell you what precisely is sorry nor what to do about it. That’s where we come in; Mike Shaw Chrysler Dodge Jeep Ram provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Extremely Qualified Service mechanical.

Check Engine Light Service 2012 Ram 5500

What do you do when you’re driving along in your Ram 5500 and rapidly, a yellow light illuminates on your dash and says "Check Engine". If you’re like most Ram owners, your heart sinks a little because you have little idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the cost of the unknown) can be just as stressful. But take a deep breath and realize the light coming on doesn’t represent you have to pull the car over to the side of the road and call a tow truck, but it is recommended that you get your 2012 Ram 5500 checked as soon as available. Ignoring that warning could end up causing intense damage to expensive engine components.

When your 2012 Ram 5500's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the electronic control system that it can’t correct, a computer turns on your check engine light. This amber or yellow light is typically labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that identifies as the issue, whether it's a sensor or a failing engine part. This code is find out with an electronic scan tool that is used by our Ram auto repair mechanics at Mike Shaw Chrysler Dodge Jeep Ram. There are also a number of relatively low-cost code readers that are designed for do-it-yourselfers, should you influence that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an trained experienced to designate the issue and repair it.

Is it safe to drive your 2012 Ram 5500 with the check engine light on?

If the check engine light is twinkling, this means that there is a critical issue and it is recommended to service your Ram 5500 promptly. This question is not very authentic because it all depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be firm to drive. This is commonly indicated by a persistent glow of the check engine light. If you notice a difference in the performance of the vehicle, it could be an indication of a more vital problem. Call the experts at Mike Shaw Chrysler Dodge Jeep Ram by dialing 9702364701 so you can describe the issues. Or reduce your speed and bring your 2012 Ram to our certified mechanics as soon as great.

2012 Ram 5500 Check Engine Light

A shining light indicates that the problem is critical and if not taken care of rapidly may result in major damage to the vehicle. If the check engine light in your 2012 Ram 5500 starts shining, that means that the problem needs prompt attention and your Ram should be brought in rapidly. This blinking light frequently indicates a serious engine misfire allowing unused fuel to be drained into the exhaust system. There it can suddenly raise the temperature of the catalytic converter to a point where damage is likely, requiring an expensive repair. A Few owners ask if spark plugs cause the check engine light to flash? This can definitely be the cause. A bad, old or dirty spark plug can cause the engine to misfire. If the problem is ignored or you continue to drive, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a excessively expensive repair. If your check engine light is shining, please contact our company of automotive experts at Mike Shaw Chrysler Dodge Jeep Ram rapidly by calling 9702364701.

How much does it cost to get the engine light checked?

The intermediate cost for a check engine light diagnosis & testing is ordinarily between $88 and $111. The favorable news, Mike Shaw Chrysler Dodge Jeep Ram offers complimentary multi-point inspections and free diagnostics, in most cases, to help elect for the cause of your check engine light. The check engine light warns of issues ranging from a gas cap that's not properly tightened to a more exacting failure like a bad catalytic converter or a problem with one of the car's oxygen sensors, so it favorable to get the prepared code reading and diagnosis.

What Does the Check Engine Light Mean?

One of the most commonly misunderstood lights or indicators in your 2012 Ram 5500 is the check engine light. The check engine light is part of the onboard diagnostics system, and displays in a few contrasting ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light illuminates in either an amber or red color and is part of the diagnostics system found on your vehicle. Onboard computers increasingly have controlled and monitored vehicle performance since the 80s and do a mixture of things for your 2012 Ram 5500. Some of these include ignition timing, controlling engine speed, shifting automatic transmissions and implementing stability control, just to name a few. With that being said, the check engine light can indicate a variety of added things. It can be as straightforward as your gas cap being loose or as perilous as engine knocking. If your check engine light is on in your 2012 Ram 5500, contact Mike Shaw Chrysler Dodge Jeep Ram. Our Ram service department can help you find out what code is turning your check engine light on or probe why your check engine light is flashing. Contact Mike Shaw Chrysler Dodge Jeep Ram today!

2012 Ram 5500 Check Engine Light Codes

The check engine light turning on can be quite intimidating to see that small light on your vehicle’s dashboard suddenly illuminates, but in reality, it is not something that should cause you to shut down in fear prudent away. If you hear the term, diagnostic trouble codes (DTC), these are just another name for check engine light codes. These are automotive computer codes stored by the ECM, also known as the OBD (on-board computer diagnostic system) in your 5500. There are hundreds of divergent codes that your check engine light can suggest. While that sounds daunting, with a small patience, tackling basic diagnostics will give you agreeable knowledge about your vehicle and will also allow that Check Engine Light to do what it is really supposed to do: be your guide. Unfortunately, effortless and willing vehicle symptoms do not always accompany an illuminated Check Engine Light. Since there are hundreds of likely OBD codes, there are also hundreds of likely reasons for the light, including:

  • Computer output circuit issues
  • Emissions controls issues
  • Old Battery
  • Fuel and air metering systems problems
  • Loose Gas Cap or Missing Gas Cap
  • Bad Spark Plugs
  • O2 Sensor
  • Transmission issues
  • Ignition system faults

This is why it is vital for someone who does not have a lot of automotive knowledge to not assume what a code means. If the engine light comes on due to a hazardous concern, you risk damaging your car added by not repairing the issue prudent away. Call Mike Shaw Chrysler Dodge Jeep Ram at 9702364701 straightaway or schedule your check engine light service online today! When your check engine light comes on, you should get it checked out swiftly by a certified Ram mechanic.

Will the check engine light reset itself?

The check engine light on your 2012 Ram 5500 will usually shut itself off if the issue or code that caused it to turn on is fixed. For example, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will turn itself off. Likewise, if your catalytic converter is going direct, and you did a lot of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your 2012 Ram 5500 light will go off after about 20-40 miles. If you drive over that reward and the light is still on, you will need to bring it in to Mike Shaw Chrysler Dodge Jeep Ram so the light and code can be double-checked and reset.

What could cause the check engine light to come on in a 2012 Ram 5500?

When your check engine light comes on, this could be as straightforward as tightening or replacing your gas cap. Likewise, the check engine light could also be a warning of a remarkable problem that could cause remarkable damage to your engine and come with a substantial repair bill. Depending on your make and model, the check engine light will illuminate or blink. A practical glow continually means something less remarkable but a flashing check engine light illustrates that your vehicle’s engine is in remarkable trouble and service is basic urgently. If your check engine light is flashing in your 2012 Ram 5500, we notably advocate not to drive the vehicle and schedule Ram service today. Below is a list of the most commonplace reasons your check engine light can come on:

  • Your O2 Sensor (Oxygen Sensor) needs to be changed. The Oxygen sensor, known as the O2 sensor, measures the fee of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns faster and your car will be less efficient when it comes to fuel economy. So what happens if I don’t replace your O2 sensor? A faulty sensor can not only affect your miles per gallon, but it can cause damage to your catalytic converter and your 2012 Ram 5500's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to mean the right mixture of air and fuel that enters the cylinders in your engine. A bad O2 sensor can also cause a car to fail an emissions test.
  • Your mass airflow sensor (known as MAF) needs to be changed. The mass airflow sensor in your Ram 5500 is what determines how much fuel is imperative to run your engine efficiently by measuring the fee of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to clear changes, like altitude. If your Ram 5500 is having trouble starting, idling rough or has a sudden change in the position of the throttle pedal, this could be a sign of a bad mass airflow sensor.
  • Issues with any aftermarket items. An aftermarket alarm, exhaust or substitute item can wreak havoc on your 2012 Ram 5500 if it’s not installed accurately. These aftermarket parts and accessories can drain the battery, trigger the check engine light, or even prevent the car from starting. If these issues sound normal, bring your 5500 to Ram and have our unit of certified mechanics ensure that your aftermarket items were installed correctly and aren't causing any issue. Getting accessories, especially aftermarket parts and accessories, or using OEM parts first place might cost a small bit more but could save you money from having to get poor function and damage caused by poor installation function corrected.
  • The battery is low or dead. The battery in your 2012 Ram 5500 is every necessary. Without a car battery, your car won’t start, light up the road ahead, play the radio or charge your phone. Today’s car batteries last much longer than they did a few decades ago, and they don't really require maintenance. The rate of a new one depends on the type of Ram you drive, but check our extant service coupons and specials.
  • One of the most normal and bountiful cause is that your 2012 Ram 5500 gas cap is loose, damaged or missing. The gas cap for your 2012 Ram 5500 serves multiple purposes. It prevents gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a bad fuel cap? If your gas cap is old or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump. Luckily, to replace a gas cap isn't pricey. If your check engine light turns on promptly after you put gas in your 2012 Ram 5500, first thing you should check is to make satisfied the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.
  • Your catalytic converter is bad or going bad. The catalytic converter is a part of your 2012 Ram 5500’s exhaust system. The catalytic converter's function is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is commonly caused by neglected maintenance, which is why Mike Shaw Chrysler Dodge Jeep Ram offers a complimentary multi-point inspection with every Ram service. If you have an issue with your catalytic converter and don't get it fixed, your 2012 Ram 5500 will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your car may run at a higher temperature, too, which can cause substitute problems from overheating.
  • Your 2012 Ram 5500 has a vacuum leak. Every Ram 5500 has a vacuum system that performs a wide variety of functions. The vacuum system also helps lower harmful emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can dehydrated out and crack, especially if they’re exposed to compelling heat or extreme heated.
  • New Spark Plugs or Plug Wires are imperative for your 2012 Ram 5500. The spark plugs are the part of your engine that ignites the air/fuel mixture in the combustion chamber of your car. This explosion is what moves the pistons and makes the engine run. The spark plug wires deliver the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are bad or old, you will experience poor performance and reduced power. In a few extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or damage to ignition coils and O2 sensors, leading to more pricey repairs.