Please wait while the page loads...

2012 Ram 4500 Check Engine Light

If the check engine light in your 2012 Ram 4500 starts flashing, that means that the problem needs fast attention and your Ram should be brought in immediately. A flashing light indicates that the problem is treacherous and if not taken care of immediately may result in major damage to the vehicle. This blinking light ordinarily expresses a strict engine misfire allowing unburned fuel to be dumped into the exhaust system. There it can quickly hike the temperature of the catalytic converter to a point where damage is feasible, requiring an pricey repair. Some owners ask if spark plugs cause the check engine light to flash? This can strictly be the cause. A harmful, aged or dirty spark plug can cause the engine to misfire. If your check engine light is shining, please contact our team of automotive mentors at Mike Shaw Chrysler Dodge Jeep Ram swiftly by calling 9702364701. If the problem is ignored or you continue to drive, this can spread to the spark plug wires, catalytic converter, or ignition coils which can lead to a very lavish repair.

2012 Ram 4500 Check Engine Light Flashing

Although there are bountiful potential causes of an illuminated Check Engine Light, we know from years of providing Check Engine Light Diagnosis Service that there are plentiful routine causes encompassing something as pure as a loose gas cap. Extra routine reasons for a Check Engine Light are faulty head gasket, a malfunction with the fuel injection system, faulty emissions control part, damaged oxygen sensor, dirty mass airflow sensor, or defective spark plugs to name a few. No matter what is the root cause of the Check Engine Light, we have the Ram Certified Technicians and the certified service protocol to isolate the root problem and repair it as needed to restore factory specifications. When this happens, the Check Engine Light turns off, and you can leave the service center knowing that your Ram issue was serviced.

Every 2012 Ram 4500 was designed with a high-technology performance monitoring system with a computer, and a series of sensors positioned strategically throughout the vehicle on its crucial systems. The sensors are continuously detecting conditions while sending data to the electronic control unit. If the electronic control unit detects that the data is out of factory specifications, the Check Engine Light illuminates telling you that there is a problem. However, that is the limitation of the Check Engine Light – it won’t tell you what exactly is awry nor what to do about it. That’s where we come in; Mike Shaw Chrysler Dodge Jeep Ram provides a Check Engine Light Diagnosis Service that isolates the core problem and gives you a recommendation on what to do next from a Highly Qualified Service expert.

How much does it cost to get the engine light checked?

The average cost for a check engine light diagnosis & testing is usually between $88 and $111. The convinced news, Mike Shaw Chrysler Dodge Jeep Ram offers complimentary multi-point inspections and free diagnostics, in most cases, to help determine the cause of your check engine light. The check engine light warns of issues ranging from a gas cap that's not properly tightened to a more powerful failure like a bad catalytic converter or a problem with one of the car's oxygen sensors, so it convinced to get the acceptable code reading and diagnosis.

What Does the Check Engine Light Mean?

One of the most continually misunderstood lights or indicators in your 2012 Ram 4500 is the check engine light. The check engine light is part of the onboard diagnostics system, and displays in some assorted ways. It can say "Check Engine", it can be a symbol of an engine, it can even be a combination of both. This light illuminates in either an amber or red color and is part of the diagnostics system found on your vehicle. Onboard computers increasingly have controlled and monitored vehicle performance since the 80s and do a variety of things for your 2012 Ram 4500. Some of these include ignition timing, shifting automatic transmissions controlling engine speed, and implementing stability control, just to name some. With that being said, the check engine light can mean a variety of different things. It can be as easy as your gas cap being loose or as adequate as engine knocking. If your check engine light is on in your 2012 Ram 4500, contact Mike Shaw Chrysler Dodge Jeep Ram. Our Ram service department can help you find out what code is turning your check engine light on or analyze why your check engine light is flashing. Contact Mike Shaw Chrysler Dodge Jeep Ram today!

How many miles can you drive with the check engine light?

If you check engine light is flashing, we advise that you pull over and contact Mike Shaw Chrysler Dodge Jeep Ram to help advocate if your vehicle is safe to travel to work in or if we advise a tow truck. The safest bet is to decipher the code and then plan your strategy accordingly. Since each check engine code has its own level of severity, it is troublesome to predict how frequent miles you can travel to work with the warning light on. It could be anything from a detrimental sensor to plug wires needing to be replenished.

Check Engine Light Service 2012 Ram 4500

What do you do when you’re driving along in your Ram 4500 and expeditiously, a yellow light illuminates on your dash and says "Check Engine". If you’re like most Ram owners, your heart sinks a little because you have little idea about what that light is trying to tell you or how you should react. The fear of the unknown (or the cost of the unknown) can be just as stressful. But take a deep breath and realize the light coming on doesn’t mean you have to pull the vehicle over to the side of the road and call a tow truck, but it is recommended that you get your 2012 Ram 4500 checked as soon as ordinary. Ignoring that warning could end up causing major damage to expensive engine components.

When your 2012 Ram 4500's ECM (electronic control module), which is the vehicle's onboard computer, finds a problem in the electronic control system that it can’t significant, a computer turns on your check engine light. This amber or yellow light is typically labeled “check engine” or “service engine soon”, or the light may be nothing more than a picture of an engine, or a picture of the engine with the word “check.”

When the light turns on, the ECM stores an engine code or “trouble code” in its memory that identifies as the issue, whether it's a sensor or a failing engine part. This code is elect for with an mechanical observe tool that is used by our Ram auto repair mechanics at Mike Shaw Chrysler Dodge Jeep Ram. There are also a number of relatively low-cost code readers that are designed for do-it-yourselfers, should you determine that route too. While this code will tell you the issue that is detected, a true diagnosis still requires an experienced skilled to indicate the issue and repair it.

Is it safe to drive your 2012 Ram 4500 with the check engine light on?

This question is not exceedingly realistic because it all depends on the severity of the issue. If the cause is a minor issue, such as a loose gas cap, it should be safe to drive. This is mostly indicated by a dependable glow of the check engine light. If you notice a difference in the performance of the vehicle, it could be an indication of a more unhealthy problem. If the check engine light is shining, this means that there is a unhealthy issue and it is recommended to service your Ram 4500 hastily. Call the experts at Mike Shaw Chrysler Dodge Jeep Ram by dialing 9702364701 so you can describe the issues. Or lower your speed and bring your 2012 Ram to our certified mechanics as soon as possible.

2012 Ram 4500 Check Engine Light Codes

The check engine light turning on can be quite intimidating to see that little light on your vehicle’s dashboard promptly lights up, but in reality, it is not something that should cause you to shut down in fear good away. If you hear the term, diagnostic trouble codes (DTC), these are just additional name for check engine light codes. These are automotive computer codes stored by the ECM, also established as the OBD (on-board computer diagnostic system) in your 4500. There are hundreds of a few codes that your check engine light can represent. While that sounds daunting, with a bit patience, tackling preeminent diagnostics will give you accessible knowledge about your vehicle and will also allow that Check Engine Light to do what it is really supposed to do: be your guide. Unfortunately, amusing and helpful vehicle symptoms do not always accompany an illuminated Check Engine Light. Since there are hundreds of likely OBD codes, there are also hundreds of likely reasons for the light, including:

  • Loose Gas Cap or Missing Gas Cap
  • Ignition system faults
  • O2 Sensor
  • Computer output circuit issues
  • Old Battery
  • Emissions controls issues
  • Bad Spark Plugs
  • Transmission issues
  • Fuel and air metering systems problems

This is why it is meaningful for someone who does not have a lot of automotive knowledge to not assume what a code means. When your check engine light comes on, you should get it checked out quickly by a certified Ram mechanic. Call Mike Shaw Chrysler Dodge Jeep Ram at 9702364701 now or schedule your check engine light service online today! If the engine light comes on due to a stringent concern, you risk damaging your car further by not repairing the issue polite away.

What could cause the check engine light to come on in a 2012 Ram 4500?

When your check engine light comes on, this could be as easy as tightening or replacing your gas cap. Likewise, the check engine light could also be a warning of a perilous problem that could cause perilous damage to your engine and come with a big repair bill. Depending on your make and model, the check engine light will illuminate or blink. A steady glow consistently means something less perilous but a blinking check engine light implies that your vehicle’s engine is in perilous trouble and service is basic quickly. If your check engine light is blinking in your 2012 Ram 4500, we tremendously advise not to drive the vehicle and schedule Ram service straightaway. Below is a list of the most decent reasons your check engine light can come on:

  • Your 2012 Ram 4500 has a vacuum leak. Every Ram 4500 has a vacuum system that performs a wide variety of functions. The vacuum system also helps lower damaging emissions by routing the fumes as gasoline evaporates through the engine. If you notice that your RPM is high in idle or randomly surges, a vacuum leak could be the cause. Over time, vacuum hoses can dehydrated out and crack, chiefly if they’re exposed to exciting heat or extreme cold.
  • Your mass airflow sensor (known as MAF) needs to be replaced. The mass airflow sensor in your Ram 4500 is what determines how much fuel is essential to run your engine efficiently by measuring the reward of air entering the engine. As a part of the engine management system, the mass airflow sensor helps adjust to specific changes, like altitude. If your Ram 4500 is having trouble starting, idling rough or has a sudden change in the position of the throttle pedal, this could be a sign of a damaging mass airflow sensor.
  • One of the most current and frequent cause is that your 2012 Ram 4500 gas cap is loose, damaged or missing. The gas cap for your 2012 Ram 4500 serves multiple purposes. It prevents gas fumes from being released when you aren't driving, it seals the fuel system and helps maintain pressure within the fuel tank. What happens if you have a damaging fuel cap? If your gas cap is old or has a ruptured seal, you can lose fuel through evaporation which will result in more trips to the pump. Luckily, to replace a gas cap isn't expensive. If your check engine light turns on urgently after you put gas in your 2012 Ram 4500, authentic thing you should check is to make sure the cap isn’t loose — or that it's still on your car’s roof or at the fuel pump.
  • New Spark Plugs or Plug Wires are essential for your 2012 Ram 4500. The spark plugs are the part of your engine that ignites the air/fuel mixture in the combustion chamber of your vehicle. This explosion is what moves the pistons and makes the engine run. The spark plug wires transport the spark from the ignition coil to the spark plugs. If your spark plugs or spark plug wires are damaging or old, you will experience low performance and reduced power. In some extreme cases, your engine will have trouble starting or continuing to run. Worn spark plugs and plug wires can cause clogged catalytic converter or damage to ignition coils and O2 sensors, gigantic to more expensive repairs.
  • The battery is low or dead. The battery in your 2012 Ram 4500 is every critical. Without a car battery, your car won’t start, light up the road ahead, play the radio or charge your phone. Today’s car batteries last much longer than they did a few decades ago, and they don't certainly require maintenance. The price of a new one depends on the type of Ram you drive, but check our current service coupons and specials.
  • Your catalytic converter is damaging or going damaging. The catalytic converter is a part of your 2012 Ram 4500’s exhaust system. The catalytic converter's function is to turn the carbon monoxide created by the combustion process into carbon dioxide. A damaged catalytic converter is usually caused by neglected maintenance, which is why Mike Shaw Chrysler Dodge Jeep Ram offers a complimentary multi-point inspection with every Ram service. If you have an issue with your catalytic converter and don't get it repaired, your 2012 Ram 4500 will not pass an emissions test, show a lack of engine performance and will negatively affect your fuel economy. Your car may run at a higher temperature, too, which can cause different problems from overheating.
  • Your O2 Sensor (Oxygen Sensor) needs to be replaced. The Oxygen sensor, conscious as the O2 sensor, measures the reward of oxygen in your exhaust system. If there is excess oxygen in your exhaust system, fuel burns faster and your vehicle will be less honest when it comes to fuel economy. So what happens if I don’t replace your O2 sensor? A faulty sensor can not only affect your miles per gallon, but it can cause damage to your catalytic converter and your 2012 Ram 4500's spark plugs. The O2 sensor sends data to the vehicle’s onboard computer to mean the good mixture of air and fuel that enters the cylinders in your engine. A damaging O2 sensor can also cause a car to fail an emissions test.
  • Issues with any aftermarket items. An aftermarket alarm, exhaust or different item can wreak havoc on your 2012 Ram 4500 if it’s not installed appropriately. These aftermarket parts and accessories can drain the battery, trigger the check engine light, or even prevent the vehicle from starting. If these issues sound conscious, bring your 4500 to Ram and have our team of certified mechanics ensure that your aftermarket items were installed correctly and aren't causing any issue. Getting accessories, chiefly aftermarket parts and accessories, or using OEM parts authentic place might cost some bit more but could save you money from having to get low work and damage caused by low installation work corrected.

Will the check engine light reset itself?

The check engine light on your 2012 Ram 4500 will usually shut itself off if the issue or code that caused it to turn on is fixed. For example, if the cause of your check engine light coming on was a loose gas cap, if it's tightened, the light will turn itself off. Likewise, if your catalytic converter is going functional, and you did various of stop-and-go driving, that may have turned on the check engine light due to the high usage of the converter. In most cases, your 2012 Ram 4500 light will go off after about 20-40 miles. If you drive over that amount and the light is still on, you will need to bring it in to Mike Shaw Chrysler Dodge Jeep Ram so the light and code can be double-checked and reset.